Subversion Repositories Code-Repo

Rev

Go to most recent revision | Show changed files | Details | Compare with Previous | Blame | RSS feed

Filtering Options

Rev Age Author Path Log message Diff
246 3862 d 4 h Kevin /KiCAD/ Finished Rev.A design for the controller PCB.  
245 3871 d 8 h Kevin /KiCAD/ Finished preliminary PCB board layout for the game controller.  
244 3872 d 4 h Kevin /KiCAD/ Added MSP23009 (I2C I/O expander) and TCL59116 (I2C LED driver) chips to the KiCAD library.
Created the schematic for the LED cube game controller board.		  
225 3910 d 12 h Kevin /KiCAD/ Changed the drill size on the RGB LED cube PCB to be slightly larger.  
221 3983 d 17 h Kevin /KiCAD/Libraries/ Updated KiCAD libraries with new parts.  
194 4097 d 10 h Kevin /KiCAD/Libraries/ Updated KiCad libraries with some new parts.  
189 4126 d 3 h Kevin /KiCAD/ Finished new project for a 12 connector liPo charger.  
188 4129 d 2 h Kevin /KiCAD/ Finished initial layout of the bluetooth IMU board.  
185 4134 d 13 h Kevin /KiCAD/ Finalized board layout for the RGB Led Cube.  
182 4144 d 19 h Kevin /KiCAD/ More or less finished the schematic for the bluetooth IMU board.  
181 4147 d 9 h Kevin /KiCAD/ Created a new project for a tiny Bluetooth IMU.  
180 4148 d 22 h Kevin /KiCAD/ Created an alternative LED Cube that uses the TCL5951 chip instead of the MAX6974 for the PWM driver.  
177 4151 d 2 h Kevin /KiCAD/ Changed footprints to match the actual parts for the boost circuit.  
176 4152 d 0 h Kevin /KiCAD/ Finished rev. 1 of the PCB for the LED Cube.  
175 4160 d 7 h Kevin /KiCAD/Libraries/ Removed old parts libraries.  
173 4160 d 7 h Kevin /KiCAD/ Imported new project for the RGB LED cube.
Added EESCHEMA and PCBNEW libraries from http://smisioto.no-ip.org/elettronica/kicad/kicad-en.htm.		  
136 4338 d 14 h Kevin /KiCAD/ Updated PIC18F27J13 breakout board to revision D0. Removed Tx and Rx LEDs and added a pulldown resistor to C5 and a button to bring C5 high.  
133 4352 d 7 h Kevin /KiCAD/ Updated PIC18F27J13 breakout board to revision C0 to add a 32.768 Crystal and rerouted board to place some components on the backside.
Replaced the 603 footprints for the 10uF capacitors on the power bridge designs with an 805 footprint.		  
132 4363 d 6 h Kevin /KiCAD/ Finished the design for a breadboard power supply as well as a board to interconnect power rails on the same breadboard and between breadboards.  
131 4363 d 12 h Kevin /KiCAD/ Updated PIC18F27J13 breakout board to revision B0 with the following changes:
- Changed PIC chip profile from SOIC to SSOP
- Changed clock crystal to smaller SMD profile
- Added I2C pullup resistors
- Added LED indicators to pins C0-C2 and C5-C7 (including UART Tx/Rx)
- Added tank capacitor to VCC input		  

←Prev12Next→

Show All