Subversion Repositories Code-Repo

Rev

Go to most recent revision | Show changed files | Details | Compare with Previous | Blame | RSS feed

Filtering Options

Rev Age Author Path Log message Diff
181 4250 d 1 h Kevin /KiCAD/ Created a new project for a tiny Bluetooth IMU.  
180 4251 d 14 h Kevin /KiCAD/ Created an alternative LED Cube that uses the TCL5951 chip instead of the MAX6974 for the PWM driver.  
179 4252 d 14 h Kevin /KiCAD/Projects/RGB Led Cube/ Fixed up a few small things and added a rendered image of the board.  
178 4253 d 13 h Kevin /KiCAD/Projects/RGB Led Cube/ Increased the width of high current traces.
Exported each layer as an SVG to allow for easier viewing.		  
177 4253 d 19 h Kevin /KiCAD/ Changed footprints to match the actual parts for the boost circuit.  
176 4254 d 16 h Kevin /KiCAD/ Finished rev. 1 of the PCB for the LED Cube.  
175 4263 d 0 h Kevin /KiCAD/Libraries/ Removed old parts libraries.  
173 4263 d 0 h Kevin /KiCAD/ Imported new project for the RGB LED cube.
Added EESCHEMA and PCBNEW libraries from http://smisioto.no-ip.org/elettronica/kicad/kicad-en.htm.		  
138 4399 d 1 h Kevin /KiCAD/Projects/ Misc changes.  
137 4441 d 6 h Kevin /KiCAD/Projects/breadboardPowerMain/ Finalized revision A1 for the breadboard PSU.  
136 4441 d 6 h Kevin /KiCAD/ Updated PIC18F27J13 breakout board to revision D0. Removed Tx and Rx LEDs and added a pulldown resistor to C5 and a button to bring C5 high.  
135 4451 d 19 h Kevin /KiCAD/Projects/ Increased annular ring size of headers by 30 mil.
Changed power regulator mounting hole to 150 mil (actual diameter of hole).		  
134 4451 d 21 h Kevin /KiCAD/Projects/breadboardPowerMain/ Changed regulator output capacitor to 805 footprint. Also corrected switch on/off text.  
133 4454 d 23 h Kevin /KiCAD/ Updated PIC18F27J13 breakout board to revision C0 to add a 32.768 Crystal and rerouted board to place some components on the backside.
Replaced the 603 footprints for the 10uF capacitors on the power bridge designs with an 805 footprint.		  
132 4465 d 22 h Kevin /KiCAD/ Finished the design for a breadboard power supply as well as a board to interconnect power rails on the same breadboard and between breadboards.  
131 4466 d 4 h Kevin /KiCAD/ Updated PIC18F27J13 breakout board to revision B0 with the following changes:
- Changed PIC chip profile from SOIC to SSOP
- Changed clock crystal to smaller SMD profile
- Added I2C pullup resistors
- Added LED indicators to pins C0-C2 and C5-C7 (including UART Tx/Rx)
- Added tank capacitor to VCC input		  
125 4491 d 4 h Kevin /KiCAD/ Import of PIC 18F27J13 v.A0 breakout board project.  
124 4491 d 4 h Kevin /KiCAD/ Created folder to hold KiCad files.