Subversion Repositories Code-Repo

Rev

Go to most recent revision | Show changed files | Directory listing | RSS feed

Filtering Options

Rev Age Author Path Log message Diff
194 4069 d 18 h Kevin /KiCAD/Libraries/ Updated KiCad libraries with some new parts.  
189 4098 d 11 h Kevin /KiCAD/ Finished new project for a 12 connector liPo charger.  
188 4101 d 11 h Kevin /KiCAD/ Finished initial layout of the bluetooth IMU board.  
185 4106 d 22 h Kevin /KiCAD/ Finalized board layout for the RGB Led Cube.  
182 4117 d 3 h Kevin /KiCAD/ More or less finished the schematic for the bluetooth IMU board.  
181 4119 d 17 h Kevin /KiCAD/ Created a new project for a tiny Bluetooth IMU.  
180 4121 d 6 h Kevin /KiCAD/ Created an alternative LED Cube that uses the TCL5951 chip instead of the MAX6974 for the PWM driver.  
177 4123 d 11 h Kevin /KiCAD/ Changed footprints to match the actual parts for the boost circuit.  
176 4124 d 8 h Kevin /KiCAD/ Finished rev. 1 of the PCB for the LED Cube.  
175 4132 d 16 h Kevin /KiCAD/Libraries/ Removed old parts libraries.  
173 4132 d 16 h Kevin /KiCAD/ Imported new project for the RGB LED cube.
Added EESCHEMA and PCBNEW libraries from http://smisioto.no-ip.org/elettronica/kicad/kicad-en.htm.		  
136 4310 d 22 h Kevin /KiCAD/ Updated PIC18F27J13 breakout board to revision D0. Removed Tx and Rx LEDs and added a pulldown resistor to C5 and a button to bring C5 high.  
133 4324 d 16 h Kevin /KiCAD/ Updated PIC18F27J13 breakout board to revision C0 to add a 32.768 Crystal and rerouted board to place some components on the backside.
Replaced the 603 footprints for the 10uF capacitors on the power bridge designs with an 805 footprint.		  
132 4335 d 14 h Kevin /KiCAD/ Finished the design for a breadboard power supply as well as a board to interconnect power rails on the same breadboard and between breadboards.  
131 4335 d 20 h Kevin /KiCAD/ Updated PIC18F27J13 breakout board to revision B0 with the following changes:
- Changed PIC chip profile from SOIC to SSOP
- Changed clock crystal to smaller SMD profile
- Added I2C pullup resistors
- Added LED indicators to pins C0-C2 and C5-C7 (including UART Tx/Rx)
- Added tank capacitor to VCC input		  
125 4360 d 20 h Kevin /KiCAD/ Import of PIC 18F27J13 v.A0 breakout board project.