Blame | Last modification | View Log | Download | RSS feed
#include <xc.h>// CONFIG1#pragma config FOSC = INTOSC // Oscillator Selection (INTOSC oscillator: I/O function on CLKIN pin)#pragma config WDTE = OFF // Watchdog Timer Enable (WDT disabled)#pragma config PWRTE = OFF // Power-up Timer Enable (PWRT disabled)#pragma config MCLRE = ON // MCLR Pin Function Select (MCLR/VPP pin function is MCLR)#pragma config CP = OFF // Flash Program Memory Code Protection (Program memory code protection is disabled)#pragma config CPD = OFF // Data Memory Code Protection (Data memory code protection is disabled)#pragma config BOREN = ON // Brown-out Reset Enable (Brown-out Reset enabled)#pragma config CLKOUTEN = OFF // Clock Out Enable (CLKOUT function is disabled. I/O or oscillator function on the CLKOUT pin)#pragma config IESO = ON // Internal/External Switchover (Internal/External Switchover mode is enabled)#pragma config FCMEN = ON // Fail-Safe Clock Monitor Enable (Fail-Safe Clock Monitor is enabled)// CONFIG2#pragma config WRT = OFF // Flash Memory Self-Write Protection (Write protection off)#pragma config PLLEN = ON // PLL Enable (4x PLL enabled)#pragma config STVREN = ON // Stack Overflow/Underflow Reset Enable (Stack Overflow or Underflow will cause a Reset)#pragma config BORV = LO // Brown-out Reset Voltage Selection (Brown-out Reset Voltage (Vbor), low trip point selected.)#pragma config LVP = ON // Low-Voltage Programming Enable (High-voltage on MCLR/VPP must be used for programming)int main() {while(1);}