Subversion Repositories Code-Repo

/* ------------------------------------------------------------ */
/* PIC32 Configuration Settings */
/* ------------------------------------------------------------ */
/* Oscillator Settings */
#pragma config FNOSC     = PRIPLL   // Oscillator Selection Bits
#pragma config POSCMOD   = EC       // Primary Oscillator Configuration
#pragma config FPLLIDIV  = DIV_2    // PLL Input Divider
#pragma config FPLLMUL   = MUL_20   // PLL Multiplier
#pragma config FPLLODIV  = DIV_1    // PLL Output Divider
#pragma config FPBDIV    = DIV_8    // Peripheral Clock Divisor (timers/UART/SPI/I2C)
#pragma config FSOSCEN   = OFF      // Secondary Oscillator Enable
/* Clock Control Settings */
#pragma config IESO      = OFF      // Internal/External Clock Switch Over
#pragma config FCKSM     = CSDCMD   // Clock Switching and Monitor Selection
#pragma config OSCIOFNC  = OFF      // CLKO Output Signal Active on the OSCO Pin
/* USB Settings */
#pragma config UPLLEN    = ON       // USB PLL Enable
#pragma config UPLLIDIV  = DIV_2    // USB PLL Input Divider
#pragma config FVBUSONIO = OFF      // USB VBUS ON Selection
#pragma config FUSBIDIO  = OFF      // USB USID Selection
/* Other Peripheral Device Settings */
#pragma config FWDTEN    = OFF      // Watchdog Timer Enable
#pragma config WDTPS     = PS1024   // Watchdog Timer Postscaler
#pragma config FSRSSEL   = PRIORITY_7   // SRS Interrupt Priority
#pragma config FCANIO    = OFF      // CAN I/O Pin Select (default/alternate)
#pragma config FETHIO    = ON       // Ethernet I/O Pin Select (default/alternate)
#pragma config FMIIEN    = OFF      // Ethernet MII/RMII select (OFF=RMII)
/* Code Protection Settings */
#pragma config CP        = OFF      // Code Protect
#pragma config BWP       = OFF      // Boot Flash Write Protect
#pragma config PWP       = OFF      // Program Flash Write Protect
/* Debug Settings */
#pragma config ICESEL = ICS_PGx1    // ICE/ICD Comm Channel Select (on-board debugger)
/* ------------------------------------------------------------ */

#include <xc.h>
#include <plib.h>
#include "defines.h"

int main() {
    /* Configure the target for maximum performance at 80 MHz. */
    SYSTEMConfigPerformance(80000000UL);

    INTConfigureSystem(INT_SYSTEM_CONFIG_MULT_VECTOR);

    LED1_TRIS = 0;
    LED2_TRIS = 0;
    LED3_TRIS = 0;
    LED4_TRIS = 0;
    LED1_PORT = 1;
    LED2_PORT = 1;
    LED3_PORT = 1;
    LED4_PORT = 1;

    while(1) {}
}