Rev 157 | Go to most recent revision | Blame | Compare with Previous | Last modification | View Log | RSS feed
#
# Generated Makefile - do not edit!
#
# Edit the Makefile in the project folder instead (../Makefile). Each target
# has a pre- and a post- target defined where you can add customization code.
#
# This makefile implements macros and targets common to all configurations.
#
# NOCDDL
# Building and Cleaning subprojects are done by default, but can be controlled with the SUB
# macro. If SUB=no, subprojects will not be built or cleaned. The following macro
# statements set BUILD_SUB-CONF and CLEAN_SUB-CONF to .build-reqprojects-conf
# and .clean-reqprojects-conf unless SUB has the value 'no'
SUB_no=NO
SUBPROJECTS=${SUB_${SUB}}
BUILD_SUBPROJECTS_=.build-subprojects
BUILD_SUBPROJECTS_NO=
BUILD_SUBPROJECTS=${BUILD_SUBPROJECTS_${SUBPROJECTS}}
CLEAN_SUBPROJECTS_=.clean-subprojects
CLEAN_SUBPROJECTS_NO=
CLEAN_SUBPROJECTS=${CLEAN_SUBPROJECTS_${SUBPROJECTS}}
# Project Name
PROJECTNAME=PICX_27J13.X
# Active Configuration
DEFAULTCONF=default
CONF=${DEFAULTCONF}
# All Configurations
ALLCONFS=default
# build
.build-impl: .build-pre
${MAKE} -f nbproject/Makefile-${CONF}.mk SUBPROJECTS=${SUBPROJECTS} .build-conf
# clean
.clean-impl: .clean-pre
${MAKE} -f nbproject/Makefile-${CONF}.mk SUBPROJECTS=${SUBPROJECTS} .clean-conf
# clobber
.clobber-impl: .clobber-pre .depcheck-impl
${MAKE} SUBPROJECTS=${SUBPROJECTS} CONF=default clean
# all
.all-impl: .all-pre .depcheck-impl
${MAKE} SUBPROJECTS=${SUBPROJECTS} CONF=default build
# dependency checking support
.depcheck-impl:
# @echo "# This code depends on make tool being used" >.dep.inc
# @if [ -n "${MAKE_VERSION}" ]; then \
# echo "DEPFILES=\$$(wildcard \$$(addsuffix .d, \$${OBJECTFILES}))" >>.dep.inc; \
# echo "ifneq (\$${DEPFILES},)" >>.dep.inc; \
# echo "include \$${DEPFILES}" >>.dep.inc; \
# echo "endif" >>.dep.inc; \
# else \
# echo ".KEEP_STATE:" >>.dep.inc; \
# echo ".KEEP_STATE_FILE:.make.state.\$${CONF}" >>.dep.inc; \
# fi