Rev 193 | Blame | Compare with Previous | Last modification | View Log | Download | RSS feed
## Generated Makefile - do not edit!## Edit the Makefile in the project folder instead (../Makefile). Each target# has a pre- and a post- target defined where you can add customization code.## This makefile implements macros and targets common to all configurations.## NOCDDL# Building and Cleaning subprojects are done by default, but can be controlled with the SUB# macro. If SUB=no, subprojects will not be built or cleaned. The following macro# statements set BUILD_SUB-CONF and CLEAN_SUB-CONF to .build-reqprojects-conf# and .clean-reqprojects-conf unless SUB has the value 'no'SUB_no=NOSUBPROJECTS=${SUB_${SUB}}BUILD_SUBPROJECTS_=.build-subprojectsBUILD_SUBPROJECTS_NO=BUILD_SUBPROJECTS=${BUILD_SUBPROJECTS_${SUBPROJECTS}}CLEAN_SUBPROJECTS_=.clean-subprojectsCLEAN_SUBPROJECTS_NO=CLEAN_SUBPROJECTS=${CLEAN_SUBPROJECTS_${SUBPROJECTS}}# Project NamePROJECTNAME=Cerebot_32MX7_LED_Cube# Active ConfigurationDEFAULTCONF=defaultCONF=${DEFAULTCONF}# All ConfigurationsALLCONFS=default# build.build-impl: .build-pre${MAKE} -f nbproject/Makefile-${CONF}.mk SUBPROJECTS=${SUBPROJECTS} .build-conf# clean.clean-impl: .clean-pre${MAKE} -f nbproject/Makefile-${CONF}.mk SUBPROJECTS=${SUBPROJECTS} .clean-conf# clobber.clobber-impl: .clobber-pre .depcheck-impl${MAKE} SUBPROJECTS=${SUBPROJECTS} CONF=default clean# all.all-impl: .all-pre .depcheck-impl${MAKE} SUBPROJECTS=${SUBPROJECTS} CONF=default build# dependency checking support.depcheck-impl:# @echo "# This code depends on make tool being used" >.dep.inc# @if [ -n "${MAKE_VERSION}" ]; then \# echo "DEPFILES=\$$(wildcard \$$(addsuffix .d, \$${OBJECTFILES}))" >>.dep.inc; \# echo "ifneq (\$${DEPFILES},)" >>.dep.inc; \# echo "include \$${DEPFILES}" >>.dep.inc; \# echo "endif" >>.dep.inc; \# else \# echo ".KEEP_STATE:" >>.dep.inc; \# echo ".KEEP_STATE_FILE:.make.state.\$${CONF}" >>.dep.inc; \# fi