| 0,0 → 1,25 |
|---|
| #include <xc.h> |
| |
| // CONFIG1 |
| #pragma config FOSC = INTOSC // Oscillator Selection (INTOSC oscillator: I/O function on CLKIN pin) |
| #pragma config WDTE = OFF // Watchdog Timer Enable (WDT disabled) |
| #pragma config PWRTE = OFF // Power-up Timer Enable (PWRT disabled) |
| #pragma config MCLRE = ON // MCLR Pin Function Select (MCLR/VPP pin function is MCLR) |
| #pragma config CP = OFF // Flash Program Memory Code Protection (Program memory code protection is disabled) |
| #pragma config CPD = OFF // Data Memory Code Protection (Data memory code protection is disabled) |
| #pragma config BOREN = ON // Brown-out Reset Enable (Brown-out Reset enabled) |
| #pragma config CLKOUTEN = OFF // Clock Out Enable (CLKOUT function is disabled. I/O or oscillator function on the CLKOUT pin) |
| #pragma config IESO = ON // Internal/External Switchover (Internal/External Switchover mode is enabled) |
| #pragma config FCMEN = ON // Fail-Safe Clock Monitor Enable (Fail-Safe Clock Monitor is enabled) |
| |
| // CONFIG2 |
| #pragma config WRT = OFF // Flash Memory Self-Write Protection (Write protection off) |
| #pragma config PLLEN = ON // PLL Enable (4x PLL enabled) |
| #pragma config STVREN = ON // Stack Overflow/Underflow Reset Enable (Stack Overflow or Underflow will cause a Reset) |
| #pragma config BORV = LO // Brown-out Reset Voltage Selection (Brown-out Reset Voltage (Vbor), low trip point selected.) |
| #pragma config LVP = ON // Low-Voltage Programming Enable (High-voltage on MCLR/VPP must be used for programming) |
| |
| int main() { |
| while(1); |
| } |
| |