| 0,0 → 1,41 |
|---|
| #include "defines.h" |
| #include "INTERRUPTS.h" |
| #include "I2C1.h" |
| |
| void Interrupt_Enable() { |
| INTCONbits.GIE = 1; |
| INTCONbits.PEIE = 1; |
| } |
| |
| void Interrupt_Disable() { |
| INTCONbits.GIE = 0; |
| INTCONbits.PEIE = 0; |
| } |
| |
| void interrupt InterruptHandler(void) { |
| |
| // Check to see if we have an I2C1 interrupt |
| if (PIR1bits.SSP1IF) { |
| I2C1_Interrupt_Handler(); |
| PIR1bits.SSP1IF = 0; |
| } |
| |
| //#ifndef UART_TX_ONLY |
| // // Check to see if we have an interrupt on USART1 RX |
| // if (PIR1bits.RCIF) { |
| // UART_Recv_Interrupt_Handler(); |
| // PIR1bits.RCIF = 0; |
| // if (INTCONbits.TMR0IF) |
| // tmr0_rollover = 1; |
| // } |
| //#endif |
| |
| // // Check to see if we have an interrupt on USART1 TX |
| // if (PIR1bits.TXIF) { |
| // UART_Send_Interrupt_Handler(); |
| //// PIR1bits.TXIF = 0; |
| // if (INTCONbits.TMR0IF) |
| // tmr0_rollover = 1; |
| // } |
| |
| } |